ThereasonwhytheairductofRaymondemillisblocked
Raymon mill air duct is the 1 kind of common industrial equipment, used to transport materials and dust. However, this equipment sometimes gets clogged, resulting in production stagnation and equipment damage. The following are several reasons for the blockage of the Raymon mill air duct:
1. Material is too large or too wet
When the materials are too large or too wet, they may stick to the inner wall of the grinding duct and eventually cause blockage. This situation can be avoided by selecting appropriate materials and controlling the moisture of the materials.
2. Improper design of the grinding duct
Improper design of the mill duct can also lead to clogging. For example, the angle of the grinding duct is too small or too large, or there are unnecessary bends and transitions, which may cause material accumulation and blockage. This situation can be avoided by optimizing the design of the mill duct.
3. The cleaning of the grinding duct is not timely
If the cleaning of the mill duct is not timely, it will accumulate enough materials and dust, which will eventually lead to blockage. Therefore, it is very important to clean the grinding duct regularly to avoid this situation.
4. Equipment aging or failure
Equipment aging or failure is also one of the reasons for the blockage of the grinding duct. For example, the impeller of the mill fan may wear or corrode, causing the material to be unable to be transported normally. This situation can be solved by regular maintenance and replacement of damaged parts.
Conclusion
In summary, there are many reasons for the blockage of the Raymonde mill air duct, but most of them can be avoided through correct operation and maintenance. Therefore, it is very important for enterprises that use the mill to regularly inspect and maintain the equipment to ensure the continuity and stability of production.
Tel：
Address：
Fax：
E-mal：
