Ultra-fine Raymond mill is the 1 kind of common industrial equipment, mainly used for processing various ores, non-metallic minerals and other materials. During use, due to the influence of various factors, the air duct will be blocked, which will affect the normal operation of the equipment. The following are the reasons for the blockage of the air duct of the ultra-fine Raymond mill:
1. Material is too wet
The ultra-fine Raymond mill needs to transport the material to the separator for separation through the air duct when processing the material. If the material is too wet, it will cause the dust to adhere in the air duct and form a blockage. Therefore, when using ultra-fine Raymond mill, it is necessary to control the moisture content of the material to ensure that the humidity of the material is within a suitable range.
2. Dust accumulation
Ultra-fine Raymond mill will produce a large amount of dust during processing, which will accumulate in the air duct, and the dust will gradually form a blockage over time. Therefore, when using the ultra-fine Raymond mill, it is necessary to regularly clean the dust in the air duct to prevent the dust from accumulating and causing blockage.
3. Improper equipment maintenance
The ultra-fine Raymond mill requires regular maintenance during use, including cleaning, lubrication, and replacement of parts. If the equipment is not properly maintained, the components in the air duct will be damaged or loose, resulting in blockage. Therefore, when using the ultra-fine Raymond mill, it is necessary to carry out correct maintenance in accordance with the equipment manual to ensure the normal operation of the equipment.
4. Unreasonable equipment design
If the air duct design of the ultra-fine Raymond mill is unreasonable, it will also lead to blockage. For example, the wind tunnel bending too much, the diameter is too small, etc. will affect the smooth flow of dust, thus forming a blockage. Therefore, when using the ultra-fine Raymond mill, it is necessary to pay attention to whether